TOM Shop
Add drawing (no clock) → Start session (time runs) → End session when done.
1 · Team
Team
Scan QR with camera, or pick from employee list.
Polish prep & finish
Open drawings in polish prep or polish finish.
No open polish prep or finish sessions.
Ready to add (carpentry done)
Open sessions by carpenter
Tap a carpenter to see their open drawings.
No open sessions for this carpenter.
2 · Client & product code
Client & code series
Register or pick the client and product code prefix only. Add each drawing in 3 · Add & start. Shop hours 9:30 AM – 6:00 PM.
Admin only — removes client when no jobs, or all sessions + client.
3 · Add & start
Drawing ref, quantity, stage, then add or start the job on the floor.
4 · Open sessions (this client)
Open sessions
No open sessions for this client.
4 · Job in progress
Job in progress
Started: —
Manufacturing: 0 h · On hold: 0 h (shop hours 9:30 AM – 6:00 PM)
Team on this job
Add or remove people above, then Save team to apply. Pick name opens the employee list.
Drawing added — Start session begins time; Add drawing saves team/stage without a clock
⏸ Session on hold — clock paused for manufacturing time
Begins manufacturing time for this drawing.
Saves team, stage, and notes — does not start the clock.
Removes the start time — drawing goes back to Added. Use if Start session was tapped by mistake.
Confirm end session
Manufacturing hours exclude time on hold. Senior scans QR to confirm.
Senior not confirmed yet
Park this job and enter a new drawing code above, then Start session.
Scan senior QR or pick senior from employee list.
No senior selected yet
Point camera at employee QR badge